格构梁设计计算系统的开发研究
摘要:格构梁作为一种新型的边坡防护体系,目前在工程实践中已广泛应用。然而工程设计中往往将格构梁拆分为单片梁计算,忽略了格构梁作为整体框架的特点,且设计主要采用手工计算和手工绘图,设计质量和设计速度都难以令人满意。基于以上考虑,利用十字交叉基础设计方法,对纵横梁的荷载分配情况进行讨论,采用Winkler弹性地基梁理论对格构梁的内力进行分析。在此基础上,将格构梁内力计算、配筋计算及施工图绘制集于一体,构建格构梁设计计算系统流程图,利用可视化程序设计语言Visual Basic结合CAD二次开发技术,开发相应的设计计算程序,实现了格构梁设计的智能化和一体化。
Abstract:As a new slope protection system, Lattice girder has been widely used in the current engineering practice, but presently lattice girder calculation will be split into single beam in the engineering design, with using the manual calculation and the hand drawing, overlooking the characteristics as a whole framework, whose design quality and design speed are not satisfactory. Based on the considerations above, the cross-based design method is used to solve the problem, which discusses the load distribution on vertical and horizontal girder, and the internal force of lattice beam is computed by Winkler elastic foundation beam theory. On this basis, internal force calculation, reinforcement calculation and construction drawings are set to be integrated, establishing the flowchart of design computing system on lattice girder, then the design calculation procedures is developed by visual programming language visual basic with CAD secondary development, and the Intelligent and integration on lattice girder design is realized.
中文标题：
格构梁设计计算系统的开发研究
Research and Development on Design Computing System of Lattice Girder
作者：
曾勇辉,刘亚
CENG Yonghui,LIU Ya
作者简介:曾勇辉,1973年生,男,广东兴宁人,工程师,主要从事岩土工程勘察、设计及施工管理方面的研究工作。E-mail:hcjt-laotou@163.com
通讯地址：
深圳市岩土综合勘察设计有限公司, 广东深圳 518172
ShenzhenComprehensiveGeotechnicalInvestigationandDesignCorporation,Shenzhen518172,Guangdong,China
中图分类号:TU311.4
doi:10.3969/j.issn.1007-2993.2010.01.004
出版物：岩土工程技术
收稿日期:2009-11-17
网络出版日期:2021-07-06
关键词:格构梁,十字交叉格构,设计计算系统,CAD技术,开发
Key words:Lattice girder,Decussating lattice,Design computing system,CAD technology,Development
文档包含图片数量：图片(0)张
文档包含表格数量：表格(0)个
参考文献：
基金项目：
- 文件大小:
- 385.19 KB
- 下载次数:
- 60
-
高速下载
|
